Energy in buildings
Energy in buildings

This free course is available to start right now. Review the full course description and key learning outcomes and create an account and enrol if you want a free statement of participation.

Free course

Energy in buildings

3 Improving heating system efficiency

Over the past 50 years the UK has been transformed from a country where the majority of homes were heated with individual coal fires to one where central heating is almost universal. In 2009, an estimated 97% of British homes were centrally heated.

An open coal fire may seem very cosy and traditional, but in practice most of the heat disappears up the chimney. The thermal efficiency of a heating system = useful heat output / fuel energy input. That of a coal fire is particularly low.

Table 9 illustrates the enormous variation in thermal efficiencies of different space heating systems.

Table 9 Thermal efficiencies of different space heating systems

Heating system Seasonal average efficiency
Open coal fire approx. 32%
New coal boiler approx. 70%
Electric fire 100%
Older gas fire approx. 50%
Typical 1980s wall-hung gas boiler approx. 65%
Gas condensing boiler >85%

In the UK, gas is the dominant central heating fuel (see Figure 27) and it also supplies half of non-centrally heated homes. Renewable energy and energy from waste meet about 1% of domestic heating energy demand.

Described image
Figure 27 GB domestic central heating (CH) fuels, 2009 (DECC, 2014a)

This growth of central heating use has been a mixed blessing for overall energy demand. The average UK dwelling today is better insulated than its 1970 counterpart, and space heating system efficiencies have increased, from an average of about 50% in 1970 to nearly 75% in 2006 (BRE, 2008). It might therefore be thought that the space heating demand of the average UK home would have fallen dramatically. However, much of the potential energy saving has been taken up as increased internal temperatures. Homes are now better heated and estimated average internal temperatures have risen from about 12°C to 18°C over the same period, increasing heat loss. It is even possible that this temperature trend will continue in the future to levels of 22°C or more found in housing in Germany and Scandinavia.

Figure 28 shows the layout of a typical domestic wet central heating system. Water is circulated through a boiler, which may be fuelled by gas, oil or solid fuel (or even an electric heat pump). The heated water flows through the radiators and through a heat exchanger in a hot water storage cylinder, which holds the domestic hot water used for washing, etc. The storage cylinder (if present) should be well-insulated – most are now supplied with a sprayed layer of foam insulation.

Described image
Figure 28 A diagram of a radiator, or ‘wet’, central heating system

There are many variants of this basic system. The most common is the combination or ‘combi’ boiler. This supplies heat to radiators but dispenses with the hot water cylinder, acting as an instantaneous heater for domestic hot water.

Such a system should obviously be properly controlled for maximum efficiency. A good system is likely to be controlled by:

  • preset time switches, or a timing programmer
  • a room thermostat that senses the air temperature, usually somewhere in the middle of the house
  • a hot water cylinder thermostat that senses the requirement for domestic hot water.

In addition individual radiators should be equipped with thermostatic radiator valves (TRVs) that provide extra local control in individual rooms.

Systems for larger buildings are likely to follow a similar pattern, but may have multiple zones that can be separately controlled. Large buildings such as hospitals are likely to use ‘warm air’ heating. Air is centrally heated (or cooled) and then blown through ducts to individual rooms.

T313_1

Take your learning further

Making the decision to study can be a big step, which is why you'll want a trusted University. The Open University has nearly 50 years’ experience delivering flexible learning and 170,000 students are studying with us right now. Take a look at all Open University courses.

If you are new to university level study, find out more about the types of qualifications we offer, including our entry level Access courses and Certificates.

Not ready for University study then browse over 900 free courses on OpenLearn and sign up to our newsletter to hear about new free courses as they are released.

Every year, thousands of students decide to study with The Open University. With over 120 qualifications, we’ve got the right course for you.

Request an Open University prospectus