Skip to content
Skip to main content

Warm forging

Updated Wednesday, 22 November 2017
The workpiece billet is heated to temperatures between 0.25 and 0.6 Tm. A close fitting punch is used to exert pressure on the malleable metal billet held in a heated, closed die until forged to the required shape.

This page was published over 6 years ago. Please be aware that due to the passage of time, the information provided on this page may be out of date or otherwise inaccurate, and any views or opinions expressed may no longer be relevant. Some technical elements such as audio-visual and interactive media may no longer work. For more detail, see how we deal with older content.

Warm forging of steel suction valve

  1. Requires accurate billet (±1 g).
  2. Billet does not need to be annealed unless combining cold and warm operations.
  3. Billet is heated by induction heater to 0.25–0.6 T(500–800°C for steel).
  4. Billet is lubricated with graphite (no need for phosphate/soap lubricants).
  5. Billet is warm forged in totally enclosed heated dies at lower loads than for cold forging.

Diagrams to demonstrate 'Warm forging' - see article

Manufacture:

  1. Warm forging is used as an alternative process to cold forging, or is combined with cold forging.
  2. Usually applied for difficult-to-cold-forge materials such as alloy steels for induction hardening applications containing 0.4–0.5 wt% C.
  3. Requires accurate weight control of billets (±1 g).
  4. Billets are heated by induction heaters to temperatures of 0.25–0.6 Tm (e.g. steels are warm forged at 500–800˚C).
  5. The billets are then coated with graphite for lubrication during warm forging.
  6. These are then forged into totally enclosed dies with no flash formation.
  7. Hot work die steels are used for punches and dies.
  8. Lower forging loads are required than with cold forging, hence smaller-capacity presses can be used: e.g. maximum punch pressures for steel are:
    cold forging (62% reduction) 2000 MPa
    warm forging (62% at 600˚C) 1450 MPa
  9. Any critical dimension might need to be tightened by the addition of an extra coining or sizing operation.

Materials:

  1. Generally the main advantage of warm forging over cold forging is that the range of materials can be extended from the soft metals into higher alloyed materials, which cannot normally be cold forged because of excessive forging loads on punches and dies.
  2. Low and medium alloy steels can be warm forged for higher duty applications or for applications requiring a change in post-heat treatment schedules (e.g. the change of low carbon case hardening steels to medium carbon (0.4–0.5% C) steels for induction hardening applications).
  3. Cr-Ni-V steels are used to produce socket heads for socket sets.
  4. Only a slight improvement in material properties compared with cold forging.

Design:

  1. Dimension and tolerance control is not as good as for cold forging.
  2. Tolerances:
    • diameter 0.3–0.6 mm
    • length 0.8–3.5 mm
    • flange thickness 0.3–0.5 mm
  3. Surface finish: slightly oxidised on steel. 1.25–2.5 μm Ra.

See Also: Cold forging, hot forging (closed die) and Orbital forging.

This article is a part of Manupedia, a collection of information about some of the processes used to convert materials into useful objects.

 

Become an OU student

Ratings & Comments

Share this free course

Copyright information

Skip Rate and Review

For further information, take a look at our frequently asked questions which may give you the support you need.

Have a question?